Compressor की wiring harness वो सेट होती है जो compressor के तीन terminals (R, S, C) को capacitor और/या PCB से connect करती है। ये wiring AC के compressor को power और स्टार्टिंग सपोर्ट देने के लिए critical होती है।

Technician के लिए जरूरी पॉइंट्स:
→ Compressor के terminals होते हैं:

R (Run) – capacitor और PCB दोनों से जुड़ सकता है

S (Start) – केवल capacitor से जुड़ता है

C (Common) – direct power supply से जुड़ता है, PCB या relay के जरिए

→ पुराने ACs में ये wiring manually की जाती थी, लेकिन नए systems में pre-fitted harness आता है जिसमें spade terminals होते हैं जो आसानी से compressor पर लग जाते हैं।
→ अगर harness में कोई wire loose, burnt या corroded हो, तो compressor चालू नहीं होगा या बार-बार trip करेगा।
→ Wrong connection से compressor की winding जल सकती है – हमेशा पहले wiring diagram या PCB पर लिखा wiring code चेक करो।

Wiring Layout Example (Split AC):
→ C (Common): goes to power input या PCB
→ R (Run): goes to capacitor (RUN terminal)
→ S (Start): goes to capacitor (START terminal)

ध्यान रखने वाली बातें:
→ Spade terminals tight और clean होने चाहिए – loose connection से heat और sparking होती है
→ अगर wires hard या brittle हो गए हैं तो पूरी harness को बदल देना ज़्यादा safe होता है
→ Compressor wiring में 2.5 sq.mm या उससे ऊपर की heat-resistant copper wire use करें
→ Harness का insulation check करो – कोई कट या burn mark न हो, नहीं तो short circuit हो सकता है

Extra Tip:
→ अगर AC PCB controlled है, तो compressor की wiring capacitor से न होकर सीधे PCB relay से भी आ सकती है – उस case में capacitor सिर्फ fan के लिए होता है
→ Multimeter से continuity और short test करना ज़रूरी है, especially जब compressor नहीं स्टार्ट हो रहा हो